User's Manual

29
TERMINAL peripherals and cables. This connector powers the terminal, charges the main
battery, and facilitates communication. This connector supports High speed USB 2.0
communication (up to 480 Mbps)
Through this connector, you can communicate with a host workstation via Microsoft
ActiveSync; see ActiveSync Communication on paragraph 10.4
The I/O connector supports the following signals:
Pin Description Direction
1 DC IN +5V PWR
2 DC IN +5V PWR
3
TXD (RS-232 )
OUT
4
RTS (RS-232 )
OUT
5 USB Host +5V Enable OUT
6 USB Host D+ IN/OUT
7 USB Host D- IN/OUT
8 USB Host Detect# IN
9
CTS (RS-232 )
IN
10
RXD (RS-232 )
IN
11 GND
12 GND
13 CRADLE Detect# IN
14 USB Client D+ IN/OUT
15 USB Client D- IN/OUT
16 USB Client +5V PWR
☞NOTE: Signals referenced are for a DTE device.
USB Port
This connector supports High speed USB 2.0 communication (up to 480 Mbps)
Also external power from the MicroUSB Adaptor that is included with the terminal. When
connected to the Handy Terminal MicroUSB Adaptor, the terminal is powered and the main
battery pack is charging.
4.15. Peripherals and Accessories
The following items are sold separately and enhance your HANDY TERMINAL’s capabilities.
Single Slot Cradle
This charging and communication cradle supports USB communication, enabling your terminal to
interface with the majority of enterprise systems. When a terminal is seated in a powered base, its
battery pack charges in five hours for the standard capacity 4000mAh pack.
For more information, see Single Slot cradle/Single Ethernet cradle Device on paragraph 12.
Single Ethernet Cradle
The Single Ethernet cradle is used to charge the battery, to power the battery charging system in
the terminal, and can be used to communicate data from the terminal to a PC/laptop via the
Ethernet port.