User's Manual

55
10.4. ActiveSync Communication
To synchronize, ActiveSync 4.1 or higher must be installed and configured for the appropriate
communication type on the host workstation and the Handy Terminal. Handy Terminals ship with
ActiveSync already installed. Therefore, if ActiveSync is already installed on the host workstation,
you just need to connect the Handy Terminal to the host workstation (via Handy Terminal
peripheral) to initiate communication.
☞ NOTE: You can download the most current version of ActiveSync (for Windows XP) or Windows Mobile Device
Center (Windows Vista, 7) from www.microsoft.com.
WARNING:
When communicating via ActiveSync, your terminal is designed to be connected to the host
workstation with a Janam communication peripheral. We recommend use of Janam peripherals, power cables, and
power adapters. Use of any non-Janam peripherals, cables, or power adapters may cause damage not covered by
the warranty.
AVERTISSEMENT : Lors de la communication via ActiveSync, votre terminal est conçu pour être connecté à une
station de travail hôte avec un périphérique de communication Janam. Nous recommandons l'utilisation des
périphériques, câbles d'alimentation et les adaptateurs électriques fournis par Janam. L'utilisation de tout autre
périphérique peut causer des dommages non couverts par la garantie.
10.5. Communication Type
The HANDY TERMINAL supports the following type of communication via ActiveSync through its I/O
connector on the bottom panel:
USB The USB cable and hardware peripherals allow the Handy Terminal to communicate with a
workstation through a USB port or to a network through a USB hub. The Handy Terminal supports
high -speed USB communication (USB 2.0); maximum data transfer rate is 480 Mbps. The Handy
Terminal defaults to USB communication out of the box.
10.6. Hardware Requirements for Setup
• AC Adaptor (if needed)
• USB ActiveSync Cable (for USB communication)