User Guide

Page 20
Display Light Menu
The DISPLAY LIGHT menu can be set to on, off, or with a two (2) minute time out. Pressing any button will turn
display light on (unless the display is set to off).
To change the Display Light
Highlight MENU/HELP and press SELECT, highlight DISPLAY LIGHT and press SELECT. Use the UP/DOWN
arrow keys to set values and the SELECT button to continue.
AquaPure™ Menu
NOTE This equipment may not be part of your system. Please check with your installer.
AquaPure Chlorine Generator systems exclusively communicate with the AquaLink RS. The AquaLink RS Control
Panel will display % of chlorine output. When interfaced with the AquaPure chlorine generator or PureLink, the
AquaLink RS allows for two different pool and spa set points for chlorine production.
This menu item will only appear when an AquaPure chlorine generator is connected to the AquaLink RS system.
To set the AquaPure Output Percentage (%)
Highlight MENU/HELP and press SELECT, highlight SET AQUAPURE and press SELECT. Inside the SET
AQUAPURE menu, select either the SET POOL TO: or SET SPA TO: and press SELECT. Use the UP/DOWN arrow
keys to set the percentage then press SELECT.
Set Time Menu
The SET TIME menu allows the correct time and date to be entered. The correct time and date ensures that
programming will work properly.
To set the Time
Highlight MENU/HELP and press SELECT, highlight SET TIME and press SELECT. Use the UP/DOWN arrow keys
to set values. Press the SELECT button to continue.
MENU
HELP
PROGRAM
SET TEMP
SET TIME
DISPLAY LIGHT
LOCKOUTS
PROGRAM GROUP
SYSTEM SETUP
SET TIME
03/01/00 WED
1:00 PM
Use ARROW KEYS
to set value.
Press SELECT
to continue
MENU
HELP
PROGRAM
SET TEMP
SET TIME
DISPLAY LIGHT
LOCKOUTS
PROGRAM GROUP
SYSTEM SETUP
DISPLAY LIGHT
LIGHT ON
LIGHT OFF
2 MIN TIMOUT
MENU
MENU
PROGRAM
SET TEMP
SET TIME
SET AQUAPURE
DISPLAY LIGHT
LOCKOUTS
PROGRAM GROUP
SYSTEM SETUP
BOOST POOL
SET AQUAPURE
SET POOL TO: 0%
SET SPA TO: 0%
Highlight an
item and press
SELECT
SET AQUAPURE
SET POOL TO: 50%
SET SPA TO: 0%
Use ARROW KEYS
to set value
Then SELECT