Use and Care Manual

31
q
ew
q
r
t
w
r
e
Tacking
q Stitch pattern: 09
w Thread tension dial: 3 to 6
e Presser foot: Satin stitch foot F
Tacking is used to reinforce pockets, crotches and belt
carriers where extra strength is needed.
• Start sewing
Start the machine and sew until the machine stops
automatically. The machine will sew a tacking 1.5 cm
(5/8˝) long.
q 1.5 cm (5/8˝)
• Sewing a shorter tack
* Set the speed control slider at low speed setting.
To sew a tack shorter than 1.5 cm (5/8˝), first stop the
machine after sewing the required length w, then press
the reverse stitch button e.
The tack length r has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
w Required length
e Reverse stitch button
r Ta ck length
t Starting point
• Sewing a same-size darning
Simply start the machine to sew another tack at the
same size.
q
ew
Eyelet
q Stitch pattern: 49
w Needle thread tension: 1 to 4
e Presser foot: Satin stitch foot F
The eyelet is used for belt holes etc.
• Starting to sew
Attach the satin stitch foot F.
Start the machine. The machine will stop automatically
when completed.
Open the eyelet with an awl, eyelet punch or pointed
scissors.
w
e
q
• Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
Press the cursor buttons to move the cursor
under the value “L3” (default setting) q.
If the eylet gap opens w, press the button to make
the darn even. (L1~L2)
If the eylet overlaps e, press the button to make the
darn even. (L4~L5)
NOTE:
The shape can be adjusted within L1 to L5 (default
setting is L3).