Operation Manual

Sewing on Buttons

Machine setting

q Pattern

w LED display

e Foot F: Satin stitch foot

r Feed dog Dropped

Adjust the Stitch width as necessary.

qw e

z x

c v b n

z Press the mode selection key to enter stitch width

adjusting mode.

Adjust the stitch width to match the needle swing

with the span of the holes on the button, by

pressing the Up (+) or Down (–) key.

x Lower the presser foot to hold the button in place.

c Turn the handwheel toward you to check if the

needle enters both left and right holes on the

button.

v Set the speed control lever at “ ” mark.

b Depress the foot control to sew 10 stitches and

stop the machine.

n Raise the foot and draw out the fabric, and trim

both needle and bobbin threads at the beginning of

stitches but leaving 20 cm (8") tails at the end.

Pull the bobbin thread to bring the needle thread

out to the wrong side of the fabric and tie the

threads together.

After finish sewing, raise the feed dog by shifting

the drop feed lever to the original position.