Operation Manual

39
Machine Setting
Pattern: 9 (mode 1)
Thread tension:3-6
Presser foot: Zigzag foot A
Foot pressure: 3
Machine Setting
Pattern: 0 (mode 1)
Thread tension:3-7
Presser foot: Overedge foot C
Foot pressure: 3
1
2
3
1
2
3
Machine Setting
Pattern: 8 (mode 1)
Thread tension:3-7
Presser foot: Zigzag foot A
Foot pressure: 3
Variety of Overcasting Stitches
Place the fabric edge next to the guide of the foot and
then sew.
1 Edge of Fabrics
2 Guide
3 Wires on Foot
CAUTION:
When you use the overedge foot C, you must set the
zigzag width at 5.0 or wider to prevent the needle from
hitting the wires on the foot.
This stitch can be used to simultaneously seam and
overcast edges of fabrics.
Use this stitch when you do not need to open seams flat.
Place the fabric edge next to the guide of the foot and
then sew.
1 Edge of Fabrics
2 Guide
3 Wires on Foot
Overcasting with zigzag stitch
Overcasting stitch
Multiple zigzag stitch (Tricot stitch)
This stitch is used to finish a raw edge of synthetics and
other stretch fabrics that tend to pucker.
Sew along the fabric edge leaving an adequate seam
allowance.
After sewing, trim the seam allowance close to the
stitches.