Operation Manual

90
The machine is started when it halts due to
the overload.
The feed dog is dropped while sewing.
The bobbin winder spindle is locked while
winding a bobbin.
Audible Signal
The Buzzer Sounds when:
pip
pip-pip-pip
Normal operation
Invalid operation or malfunction
Warning Sign
Cause
The machine is out of order due to a
problem in the control circuit.
The power is turned on again after auto
thread cutting has been interrupted.
The presser foot is raised before auto
thread cutting is completed.
The elongation button is pressed when a
pattern that cannot be elongated has
been selected.
The LCD screen shows an
abnomal display.
Turn the power off and turn it on again.
The twin needle button is pressed when a
pattern unsuitable for twin needle sewing
has been selected.
The memory button is pressed when a
pattern that cannot be memorized
has been selected.
The machine is started without lowering the
feed dog when you select the basting or
free motion quilting.
Try this
Elongation is applicable only to
satin stitches.
Select a memorable pattern.
Lower the feed dog
Sew with a single needle.
Press the Thread cutter button to
finish auto thread cutting.
Wait for at least 15 seconds to
restart. Remove tangled threads
around hook race and auto thread
cutting device.
Do not drop or raise the feed dog
while the machine is running.
Turn off the power and remove
tangled threads.
Contact the service center or the
store from whom the machine
was purchased.