Integration Guide
Table Of Contents
- 1 General Information
- 2 Specifications
- 3 Installation
- 4 Connector Pin Assignments
- 5 Preventive Maintenance
- 6 Interface Schematic Circuit Diagrams
- 7 Operational Flowcharts
- 8 Troubleshooting
- 9 Unit Dimensions and Maintenance Space Requirement
- 10 Technical Contact Information
- 11 Index
- Issue #4126-IGEF-01-00
Section 4 iVIZION™2 Series Banknote Validator Foundation of Intelligent Validation Connector Pin Assign-
P/N 960-000231R_Rev. A © 2022, JAPAN CASH MACHINE CO., LTD.
20
Bezel Connector (CN7)
Table 18 Bezel Connector Pin Assignments
Pin No. Signal Name
I/O
*
*. I/O (input/output) is the terminal as viewed from the Unit’s side.
Function
1
NC -
-
2- -
Polarizing Key
3 NC -
-
45VOUT
5V DC Power Supply (Maximum 300mA)
5 VIN OUT
LED Drive Power Supply (to iVIZION2) (Maximum 300mA)
6GND
SG
†
†. SG = Signal Ground
-
7 LED POWER OUT
LED Power Supply 5V, Current Limitation Resistance (Maximum 20mA )
8LED 1 IN
LED Drive Line (cathode) Maximum Sink Current: 300mA
Header (Validator): A3B-8PA-2DS (61) (HRS)
Socket Housing (Bezel): A3B-8D-2C (HRS)
Contact Type (Bezel): A3B-2630SCFC (HRS)
Polarizing Key: A3-GPIN (HRS)
Recommended Wire: UL1007 AWG#24-#30
NOTE: The numbers marked on the Bezel
Connector (Socket Housing) and that of
CN7 (see Table 18 below) are differently
located. The Polarizing Key should be
inserted into Pin #4 of the Bezel
Connector.
CN7
Polarize Pin #4
4
85
1
7
2
8
1
(Validator CPU Board)
Connector
(Bezel)