Integration Guide
Table Of Contents
- 1 General Information
- 2 Specifications
- 3 Installation
- 4 Connector Pin Assignments
- 5 Preventive Maintenance
- 6 Interface Schematic Circuit Diagrams
- 7 Operational Flowcharts
- 8 Troubleshooting
- 9 Unit Dimensions and Maintenance Space Requirement
- 10 Technical Contact Information
- 11 Index
- Issue #4126-IGEF-01-00
Section 8 iVIZION™2 Series Banknote Validator Foundation of Intelligent Validation Troubleshooting
P/N 960-000231R_Rev. A © 2022, JAPAN CASH MACHINE CO., LTD.
34
LED Error Codes; Banknote Jam
Blue Flashes
(7)
.
.
.
(14)
Reserved - -
Table 23 LED Error Codes; Banknote Jam
Status LED Error Solution Relative Part/Sensor
Yellow
Flashes
(1)
Reserved - -
Yellow
Flashes
(2)
Entrance Sensor/Center-
ing Sensor Jam
A Banknote jam occurred
near the Entrance and/or
Centering Sensor
• Remove a jammed Banknote or
foreign object if any.
• Check that the relative Part(s) are
properly assembled and/or
Harness are connected.
• Clean and calibrate the relative
Sensor(s).
• Entrance Sensor
• Centering Sensor
• Sensor Board LED1, PT1, CN1
• Validation CPU Board CN7
Yellow
Flashes
(3)
Reserved - -
Yellow
Flashes
(4)
PB-In Sensor Jam
A Banknote jam occurred
near the PB-In Sensor
• Remove a jammed Banknote or
foreign object if any.
• Check that the relative Part(s) are
properly assembled and/or
Harness are connected.
• Clean and calibrate the relative
Sensor(s).
• PB-In Sensor
• Sensor Board LED2, PT1, CN1
• Validation CPU Board CN7
Yellow
Flashes
(5)
Reserved - -
Yellow
Flashes
(6)
PB-Out Sensor/Exit Sen-
sor Jam
A Banknote jam occurred
near the PB-Out and/or Exit
Sensor
• Remove a jammed Banknote or
foreign object if any.
• Check that the relative Part(s) are
properly assembled and/or
Harness are connected.
• Clean and calibrate the relative
Sensor(s).
• PB-Out Sensor
• Exit Sensor
• Validation CPU Board PL3, PT1,
CN2
• Control CPU Board CN4
Yellow
Flashes
(7)
Cash Box Inside Jam
A Banknote jam occurred in
the Cash Box
• Remove a jammed Banknote or
foreign object if any.
• Check that the relative Part(s) are
properly assembled and/or
Harness are connected.
• Clean and calibrate the relative
Sensor(s).
• Stack Motor
• Pusher Plate
• Box Home Position Sensor
Yellow
Flashes
(8)
.
.
.
(15)
Reserved - -
Table 22 LED Error Codes; ICB (Continued)
Status LED Error Solution Relative Part/Sensor