User's Manual

H-7YCPD0002-0 EDITION 1
68
MESSAGE
NAME
DESCRIPTION
SYS KEY
System Key
Displayed on line 1 of the display in the display key mode of
the menu. It is followed in the second line with a key
number “KEY = <1..7>”.
KEY=1-7
Displayed on line 2 of the display in the display key mode of
the menu for conventional systems when the “SYS KEY” or
“CHN KEY” is displayed in line 1 and for trunked systems
when the “SYS KEY” or “GRP KEY” is displayed in line 1.
PRIMARY
Displayed on line 1 of the display when the primary keys
are enabled.
PRS
NAME
Personality
Name
Displayed on line 1 of the display under the revision
selection of the menu. The personality name is displayed on
line 2 at the same time.
JRC
Displayed on line 1 of the display under the revision
selection of the menu. The copyright year is shown in line 2
of display at the same time “(c) 2007.”
9.3 ALERT TONES
The JHM-875S35J mobile radio also provides audible alert tones or “beeps” to indicate the
various operating conditions. These alert tones can be enabled or disabled through
programming.
Table 9-3: JHM-875S35J Alert Tones
NAME
TONE
DESCRIPTION
Call Originate
A short mid-pitched
tone.
Sounds after keying the radio (Push-To-Talk
button is pressed). Indicates the radio has been
assigned a working channel
Carrier Control
Timer
Five short high-pitched
warning tones followed
by a long low-pitched
tone.
Sounds if the programmed time for continuous
transmission is exceeded. The transmitter will
shut down shortly after the alert, interrupting
communications. Release and re-key the PTT
button to maintain communications. This will
reset the carrier control timer and turn the
transmitter back on.
Key Press Alert
A short tone.
Indicates a key has been pressed. A short low-
pitched tone indicates no action was taken
because the key is not active in the current mode.