User's Manual

5-44

ID displayed at SENSOR STATUS is shown below list.
Talker device ID Talker device ID
Heading/track controller (autopilot) general AG Heading sensors: gyro, non-north seeking HN
magnetic AP Hull door controller/monitoring system HD
Automatic identification system AI Hull stress monitoring HS
Bilge system BI Integrated instrumentation II
Bridge navigational watch alarm system BN Integrated navigation IN
Communications: digital selective calling (DSC) CD LORAN: LORAN-C LC
Communications: data receiver CR Navigation light controller NL
Communications: satellite CS Proprietary code P
Communications: radio-telephone (MF/HF) CT Radar and/or radar plotting RA
Communications: radio-telephone (VHF) CV Propulsion machinery including remote control RC
Communications: scanning receiver CX Sounder, depth SD
Direction finder DF Steering gear/steering engine SG
Duplex repeater station DU Electronic positioning system, other/general SN
Electronic chart system (ECS) EC Sounder, scanning SS
Electronic chart display and information system (ECDIS) EI Turn rate indicator TI
Emergency position indicating radio beacon (EPIRB) EP Microprocessor controller UP
Engine room monitoring system ER Velocity sensors: Doppler, other/general VD
Fire door controller/monitoring system FD Velocity sensors: speed log, water, magnetic VM
Fire extinguisher system FE Velocity sensors: speed log, water, mechanical VW
Fire detection system FR Voyage data recorder VR
Fire sprinkler system FS Watertight door controller/monitoring system WD
Galileo positioning system GA Water level detection system WL
Global positioning system (GPS) GP Transducer YX
GLONASS positioning system GL Timekeeper, time/date: atomic clock ZA
Global navigation satellite system (GNSS) GN Timekeeper, time/date: chronometer ZC
Heading sensors: compass, magnetic HC Timekeeper, time/date: quartz ZQ
Heading sensors: gyro, north seeking HE Timekeeper, time/date: radio update ZV
Heading sensors: fluxgate HF Weather instrument WI
5.3.3.5. Event Log
Select 5.EVENT LOG at “MAINTENANCE” menu screen (refer to “5.3.3 MAINTENANCE”), “EVENT
LOG” screen is displayed and Event log (e.g. Power ON/OFF) can be displayed up to 20 events.
The stored logs are shown below.
1. POWER ON/OFF
2. SILENT MODE ON/OFF
3. MALFUNCTION ON
To switch to “MAINTENANCE” menu screen, press CLR key.
When “” or “” mark is displayed at the left side, Press  key or  key to see next.
5.3.3.6. Software Version
Select 6.SOFTWARE VERSION at “MAINTENANCE” menu screen (refer to “5.3.3 MAINTENANCE”),
“SOFTWARE VERSION” screen is displayed.
To switch to “MAINTENANCE” menu screen, press CLR key.
'8'06 .1)
219'4 10




 
219'4 1((




 
219'4 10
Ť 



 
51(69#4' 8'45+10
64#05210&'4
%106 
%10641..'4
%106 
.#0  