User's Manual

5-59
5.3.4.7 Change Password (PASSWORD)
Select 7. PASSWORD, Password screen is displayed.
In this menu, set the password that is used in case power off or channel change.
The password is managed by ship’s administrator.
Select 1.USER LEVEL and press ENT key.
If CLR is selected, the display is switched to SET UP menu screen.
1. The cursor is on the right side of “OLD” and another cursor is displayed in the character pad at the
same time.
2. Input the current password after “OLD:” by using character pad.
3. After 4 digits input, select [ENT] and press ENT key.
࡮ If the password is not matched with current one, the cursor returns to the first digit.
࡮ Factory default password is set “0000”.
࡮ If the password is matched with current one, the cursor move to first digit of “NEW”.
4. Input the new 4 digits password at ”NEW:”
5. Press ENT key at last digit
࡮ If [ENT] is selected, new screen is appeared and the cursor is at [SAVE].
࡮ If [EXIT] is selected, discard the input and return to PASSWORD screen.
6. At the above screen
࡮ Select [SAVE], new password is saved and display switches to SET UP menu
࡮ Select [EXIT] , discards the input and display switches to the PASSWORD screen.
If password setting is not completed, Popup screen (as shown
left) appears.
In this case, Select [SAVE] again or change to another
password.
Note) Password is composed of alphanumeric “A㨪Z” and “0㨪9”.
2#55914&
75'4 .'8'.
75'4 .'8'.
1.&  
0'9 
# $%&'()*+,-./01234567
89:;< 
=
᳖
?
A








!
"


@


=
'06
?
=
':+6
?
75'4 .'8'.
1.& 
0'9 
=
5#8'
?
=
':+6
?
75'4 .'8'.
4'57.65'6 0)
=
1-
?