Instruction Manual

Operation
4-58
4.7 Other features
In addition to the features described above, the equipment contains useful some features as below.
4.7.1 Notification of registered ships by the AIS
If the AIS have been installed and set to available by the following procedure (and the menu 9.6 AIS
function), when ships registered in the contact list falls within the specified range, a popup screen will
be displayed immediately and notifies the ship's information by the name or 9-digit identity (MMSI).
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select the 5. AIS
information.
The example at right shows the factory
default setting.
2
2
2
.
.
.
To activate this function, select the line of
2. Rgst ships check, and after pressing ENT,
set the condition to ON with the jog dial.
3
3
3
.
.
.
Press ENT.
If changing the proximity range, after pressing ENT
again, input the appropriate value within the range of
0.1 to 99.9NM with the numeric keypad or jog dial.
4
4
4
.
.
.
After completed the proximity range setting,
the cursor will move to the 0. Back.
When detected the registered ship within the
specified proximity range, the popup screen as
shown at right will be appeared immediately.
However, if the AIS information does not
contain the ship's name, the name line will be
replaced by the MMSI number.
5)AIS information
1.Other ships list
2.Proximity check :OFF
tip)Notify of when listed-ship
fall within the range.
3.Proximity range :20.0NM
0.Back
Note
5)AIS information
1.Other ships list
2.Proximity check :ON
tip)Notify of when listed-ship
fall within the range.
3.Proximity range :20.0NM
0.Back
5)AIS information
1.Other ships list
2.Proximity check :OFF
tip)Notify of when listed-ship
fall within the range.
3.Proximity range :20.0NM
0.Back
5)AIS information
1.Other ships list
2.Proximity check :OFF
tip)Notify of when listed-ship
fall within the range.
3.Proximity range :20.0NM
0.Back
Note