Instruction Manual

ManualsBrandsJapan Radio ManualsElectronicsMarine VHF Radio Telephone

Table Of Contents

Operation

4-7

4.2.4 Receiving with scanning

Scanning function enables to watch multiple channels (additional channels) with the priority channel

(CH16). If found receiving signal on the additional channels, the dwell time on that channel will be

longer, but continued to watch the CH16 alternatively. The scan mode can be selected from the

following modes.

・ All CH scan Mode: Scans all channels in the current channel mode.

・ Memory CH scan Mode: Scans all memory channels.

・ Select CH scan Mode: Scans the specified range of channels.

■ Procedure ■

Press FUNC Î 2SCAN

The menu will be displayed as shown at right.

Move the cursor to the desired item and

press ENT using the jog dial, or press the

item number by a numeric key directly.

¾ If selected "1. All CH scan" or "2. Memory CH

scan", scanning starts immediately.

¾ If selected "3. Select CH scan", specify the

channel range as described below.

1) To set the start channel (From):

Press ENT and after entering the

channel number, press ENT again.

2) To set the stop channel (To):

Press ENT and after entering the

channel number, press ENT again.

3) To start the scanning:

Select Execute and press ENT. Then

starts the scanning as shown at right.

- Disabled to scan when the channel

region is Inland Waterways (IWW).

- CH70 will be skipped, even if

contained in the scanning range.

To terminate scanning, press the CANCEL key.

¾ After terminated, the radiotelephone will be set

on the last additional channel. (The example at

right shows when stopped on CH12.)

¾ Scanning will be also terminated when detected

off-hook, PTT ON, or press the CH16 key or

the DISTRESS key.

- While scanning, the radiotelephone scans CH16 and the additional channels

alternatively in a cycle of 0.14/0.86 seconds.

- If the squelch is opened on the CH16, paused scanning and continues to watch on

7.1)Scan

1.All CH scan

2.Memory CH scan

3.Select CH scan (ITU)

- From : CH

- To : CH

- Execute

0.Back

Note