Instruction Manual

Operation
4-15
5
5
5
.
.
.
Press ENT to transmit the call.
After completed the transmission, the popup
screen shown at right will be displayed to wait
the acknowledgement.
If received no response for 5 minutes,
the screen will return to the step 3
mentioned above.
6
6
6
.
.
.
When received the acknowledgement, the
screen shows the message with the alarm
for 3 sec. Then changes to the working
channel proposed by the coast station
automatically.
- If 9.5.2 Automatic CH shift is OFF,
lifting the handset or pressing ENT
is required to set the proposed
working channel.
- If an improper channel is proposed,
resend the call containing a new
channel via the specified new
channel proposal form screen.
7
7
7
.
.
.
The coast station call will be completed
after displayed the working channel as
shown at right.
Start communications using the handset.
¾ The example at right shows when proposed
CH12 as a working channel.
¾ When completed the communications, return
the handset to the cradle.
If the coast station is unable to comply with the call, own station (caller) may receive
one of the following responses may be received. In these cases, if possible according
to the message, wait and retry the calling again later.
Message Content
No reason No reason.
Congestion The marine exchange center is congested.
Busy Busy.
Queue The call has been queued.
Barred The station is closed.
No operator Existing no operator.
Temp no oper The operator is temporarily away.
EQP disabled The equipment has been disabled.
Unable channel The proposed channel cannot be used.
Unable mode The proposed mode cannot be used.
Note
1.1)Coast station call
Address :[001234567]
[
Call
]
[
Cancel
]
Waiting for
Acknowledgement.
[Cancel]
Note
Note
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
12
CH
CH70
[ITU]
SQL
CH
SW
Received routine message
Format :Individual ACK
From :001234567......
Type :All modes RT...
Work CH :12.............
EOS :ACK BQ.........
Station1 TIME 23:59(UTC)
16
CH70
Press CANCEL to silence alarm.
CH
[ITU]