Instruction Manual

Operation
4-24
5
5
5
.
.
.
Press ENT.
Confirm the entered contents.
6
6
6
.
.
.
If the contents are correct, press ENT.
The sending confirmation screen will appear.
The controller displays by default only
the edited information in the call setup
as shown at right.
7
7
7
.
.
.
Press ENT to transmit the call.
After completed the transmission, the popup
screen shown at right will be displayed to wait
the acknowledgement.
If received no response for 5 minutes,
the screen will return to the step 5
mentioned above.
8
8
8
.
.
.
When received the acknowledgement, the
screen shows the message with the alarm
for 3 sec. Then changes to the proposed
working channel automatically.
- If 9.5.2 Automatic CH shift is OFF,
lifting the handset or pressing ENT
is required to set the proposed
working channel.
- If an improper channel is proposed,
resend the call containing a new
channel via the specified new
channel proposal form screen.
9
9
9
.
.
.
The ship station call will be completed
after displayed the working channel as
shown at right.
Start communications using the handset.
¾ The example at right shows when proposed
CH06 as a working channel.
¾ When completed the communications,
return the handset to the cradle.
If the ship station is unable to comply with the call, as with coast stations, own station
(caller) may receive a negative acknowledgement mentioned above section. In this
case, if possible according to the message, wait and retry the calling again later.
Note
1.2)Ship station call
Address :112233445
Work CH :06
[
Call
]
[
Cancel
]
Note
1.2)Ship station call
Address :[112233445]
Work CH :[06]
[
OK
]
[
Cancel
]
1.2)Ship station call
Address :123456789
Work CH :71
[
Call
]
[
Cancel
]
Waiting for
Acknowledgement.
[Cancel]
Note
Note
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
06
CH
CH70
[ITU]
SQL
CH
SW