Instruction Manual

Operation
4-65
4.8 Popup screens
The contents of the popup screens are as follows. (in alphabetical order)
Message Buttons Description
Acknowledged!
Accept it and abort this menu immediately?
Accept/ Ignore
Received a DSC acknowledgement
(ACK BQ) during menu operation.
Accept: Closes the menu and shows
the message immediately.
Ignore: Closes this popup only.
Acknowledged!
From: xxxxxxxxx
Shifting CH now...
-----
Received a PSTN acknowledgement
from the coast station
(MMSI: xxxxxxxxx),
and the transceiver is shifting to the
specified work channel now.
AIS information
Detected this ship in the vicinity.
MMSI: xxxxxxxxx
OK
Detected the ship
(MMSI: xxxxxxxxx) in
the AIS information within the specified
sea area.
AIS information
Detected this ship in the vicinity.
xxxxxxxxxxxxxxxxxxxx
OK
Detected the ship
(named xxxxxxxxxxxxxxxxxxxx)
in the AIS information within the
specified sea area.
Attention!
DSC usage is NOT allowed on Inland
Waterways.
Continue/ Cancel
DSC usage is NOT allowed on Inland
Waterways.
Continue: Enforces the DSC operation.
Cancel: Ceases the DSC operation.
Attention!
Specified a duplex channel used for a coast
station comm.
Continue/ Cancel
When calling a ship or a group by the
DSC, specified a duplex channel as a
work channel, which is used for a coast
station communication.
Continue: Enforces the operation.
Cancel: Ceases the operation.
Attention!
Normally, this call should be sent to a coast
station.
Continue/ Cancel
When sending a distress relay call, it
should be normally addressed to a
coast station.
Continue: Continues the operation.
Cancel: Ceases the operation.
Attention!
Restarting distress call soon...
-----
DSC resends the distress call
automatically soon.
Attention!
Send this call only when being directed by
administration.
Continue/ Cancel
To send the distress acknowledgement
or the distress relay acknowledgement,
the consulting with RCC or a coast
station is necessary.
Continue: Continues the operation.
Cancel: Ceases the operation.
Channel connection completed.
Lift handset please.
-----
The channel connection via the DSC
has been completed. Please start the
communication using the handset.
Channel dial op is invalid right now.
To enable it, press FUNC, and ENT.
-----
The channel operation with the jog dial
is disabled right now. To enable it,
press the FUNC key and ENT in
order.
CHxx SQL Setting
Register or erase the SQL level?
REG/ Erase
Register or erase the preset squelch
level of the xx channel.
REG: Registers the current level.
Erase: Erases the preset condition.