Instruction Manual

Settings & Registrations
5-14
5.6.2 Printer property
When connecting the printers, configure the conditions as appropriate according to the printer type, as follows.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through hierarchical
menus, select the 9.7 Printer property.
2
2
2
.
.
.
Select the intended printer and press ENT.
When selected the 1. Controller printer, the screen at right
will be displayed.
3
3
3
.
.
.
Move the cursor to the desired item and press ENT.
The cursor will move to the right. After that, select the
condition as appropriate and press ENT.
- The content and the selective conditions of each item are as follows.
Printer type Selective item Content
Selective conditions
( : Factory default)
Connection Connection status and the printer type None/ Serial
Data out Printing method for the DSC message Auto/ Manual
Baudrate Transmission speed to the printer 4.8k/ 9.6k/ 38.4kbps
Flow control Handshake setting with the printer Hard/ None
Controller printer
Print direction Printing sequence of the lines
Invert/ Upright
Connection Connection status and the printer type None/NKG-52/Centronics
Data out Printing method for the DSC message Auto/ Manual
Transceiver printer
Print direction Printing sequence of the lines
Invert/ Upright
(NKG-52: “Invert” only)
Note
9.7)Printer property
1.Controller printer
2.Transceiver printer
0.Back
9.7.1)Controller printer
1.Connection :None
2.Data out :Auto
3.Baudrate :4.8k
4.Flow control :Hard
5.Print direction:Invert
0.Back
9.7.1)Controller printer
1.Connection :None
2.Data out :Auto
3.Baudrate :4.8k
4.Flow control :Hard
5.Print direction:Invert
0.Back