Instruction Manual

Operation
4-20
4.3.4 Communicating with a PSTN subscriber
The semi/auto mode is available to connect with a public telephone network (PSTN) via a coast station.
(1) Make a call to a PSTN subscriber
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select the menu 1.3
PSTN call.
The menu shown at right will be displayed.
If entered previously, the address and the TEL
number will be appeared as a default value.
Additionally, in the case of JHS-780D, "Type"
line will be shown to select the mode from
"All modes RT" or "Duplex RT".
2
2
2
.
.
.
As with the routine calls mentioned above,
enter the address and press ENT.
The cursor will move to the TEL No.
3
3
3
.
.
.
Press ENT to display the alphabetically
sorted TEL number list. After selecting
the initial letter and pressing ENT, select
the recipient of the call with the jog dial.
- This list can be registered in the
menu 9.4.4 PSTN number list.
- When inputting the TEL number
manually, press the CANCEL
key to return to the previous
screen, and input it using the
numeric keypad.
4
4
4
.
.
.
Press ENT.
Confirm the entered contents.
5
5
5
.
.
.
If the contents are correct, press ENT.
The sending confirmation screen will appear.
The controller displays by default only
the edited information in the call setup
as shown at right.
1.3)PSTN call
Address:[00 ]
TEL No.:[ ]
[
OK
]
[
Cancel
]
Note
1.3)PSTN call
Address:[001234567]
TEL No.:[ ]
[ OK ] [Cancel]
1.3)PSTN call
Address :001234567
TEL No. :1122334455667788
[Call] [Cancel]
1.3)PSTN call
Address:[001234567]
TEL No.:[1122334455667788]
[ OK ] [Cancel]
Note
TEL number list [A]
NAME Heading num
Alex 11223344556
Andy
Arnold
Blanco
Bob
00125412345
01011448851
00102875521
001149586
Select the initial of the name.
ABCDEFGHIJKLMNOPQRSTUVWXYZ