User's Manual

Names and Functions
2-4
2.2.2 Operating display
(1) General
After setting the frequency, pressing PTT key in TEL mode, sending/receiving messages in
DSC/TLX mode, and things like that, the controller shows the operating display as follows.
1. Indicates the MMSI and the latest position
and that time.
2. Indicates an focused screen with sign
and thick-frame, i.e. the operating display
is divided into three screens as below,
where the focused screen can be moved
using the FUNC key for clockwise.
3. Indicates the transceiver setting screen
similar to the status display. Icons on this
area are as follows.
z Scanning :
z Not tuned yet :
z Tx power reduction :
z Turned the PA ON :
z Attenuation (dB) :
z AGC (
Fast/ Slow) :
z
Noise reduction (NR1/NR2/BC) :
4. Indicates the S meter and watchkeeping
receiver monitoring frequencies mentioned
above.
5. Indicates the existing procedures. If the
procedure is under operation (active), A
mark is added in the box frame. Further, if
other procedures on hold exist, they are
indicated in the other box frames and are
selectable to operate at any time. And
while this screen is focused, the turning
dial animation is shown as below.
6. Indicates the content and the handling
menus of the procedure located at the top
of the procedure list screen.
During operating an active procedure, any functions such like the DSC automatic
acknowledgement become invalid to avoid the ongoing communication interruption.
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59 (EXT)
Communicating on
TEL Rx:13077.0/Tx:12230.0kHz
Tip)Use FUNC to change op area.
[HLD][END]
AA
TEL
13077.0
12230.0
DUP
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59 (EXT)
Communicating on
TEL Rx:13077.0/Tx:12230.0kHz
Tip)Use FUNC to change op area.
[HLD][END]
AA
TEL
13077.0
12230.0
DUP
3
1
2
5
6
Transceiver
setting
Procedure
list
Message/event
control
Note
4