User's Manual

Operation
4-10
4.2.4 Communicating in CW mode
Use a CW keyer to communicate in CW mode.
■ Procedure ■
1
1
1
.
.
.
When operating on a controller without
access rights (OCC is displayed), press the
jog dial to obtain the access rights.
Unless the controller with access rights is being
used, the access rights are acquired and the OCC
display on the screen disappears.
2
2
2
.
.
.
Press the CW key.
¾ The communication mode is set to CW and
the previous frequency (or the default
frequency at just after turning on) is set.
¾ Pressing the CW key again turns the
power to the PA on and off.
¾ If the power to the PA is on, ON is displayed
as shown at right.
3
3
3
.
.
.
Set the frequency for making calls in CW
mode.
-
When setting a frequency, the screen
becomes operating display as shown
at right.
-
The frequency is set on the receiving
status in the status display. For
details, see "4.3.1 Setting the
communication frequencies" and
"4.3.2 Setting the communication
channels".
- See the frequency for making calls
in the appendix "11.4 ITU channel
list (TEL/CW/TLX)".
4
4
4
.
.
.
Adjust the volume of the loudspeaker by
turning the volume control.
5
5
5
.
.
.
Turn the RF GAIN control to an appropriate
reception level.
CW ITU- 401
4182.0
4182.0
RX kHz
TX kHz
NonDST: +
DROBOS: +
EdtDST: +
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59 (EXT)
SIG
WKR scan bands:
2 4 6 8 12 16MHz
Note