User's Manual

Operation
4-28
(3) Setting user channels
A total of 20 groups with 20 channels set to each group (i.e. 400 channels) can be registered on
the equipment. This section explains how to set channels that are already registered.
■ Procedure ■
1
1
1
.
.
.
Use the CH key to set the display to the user
channel mode status display.
2
2
2
.
.
.
Pressing ENT causes the channel group
number to blink so a channel group can be
input.
Use the numeric keypad or jog dial to input the
number of a registered group.
When 2 is
input using the numeric
keypad, it appears on the far right
as shown in the screen on the right.
3
3
3
.
.
.
After inputting a group number, pressing ENT
causes the channel number to blink so a user
channel can be input.
Use the numeric keypad or jog dial to input the
number of a registered channel.
When 3 is input using the numeric
keypad, it appears on the far right
as shown in the screen on the right.
4
4
4
.
.
.
Input the rest of the digits and press ENT.
¾ The input user channel frequency is
displayed and the settings are complete.
¾ The group name is displayed for 3 seconds
after the settings are done.
- Channels can be set directly in the status display or the operating display by
using the numeric keypad or the jog dial without setting a channel group. After
inputting with the numeric keypad, press ENT.
- See "5.4 Registering user channels" for how to register frequencies to user
channels.
- The user channel of the telex mode is set with the menu of the data terminal,
as Tune Î Frequency list.
Note
Note
Note
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59 (EXT)
Communicating on
TEL Rx: 4357.0/Tx: 4065.0kHz
Tip)Use FUNC to change op area.
[HLD][END]
AA
TEL
4357.0
4065.0
U20- 3