User's Manual

Operation
4-33
4.3.9 Scanning the Rx frequencies
（１） Scanning of channels in TEL/DSC/CW mode
The scanning of channels in the TEL/DSC/CW mode is started with the controller.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, after 5.4 Receiver
appears, move the cursor to 7. Scan.
2
2
2
.
.
.
Press ENT to confirm the selection.
The group list as shown at right is displayed.
- The previous scan can be restarted
by pressing and holding the FUNC
key and then pressing the
2SCAN key on the status display.
- If the user channel is not registered,
scan cannot be done so the screen
shown at right is not displayed.
3
3
3
.
.
.
Select the channel group to scan with the
cursor and press ENT.
The popup screen as shown at right is
displayed.
If the popup screen shown at right
is displayed during scanning, Stop
appears instead of Execute.
4
4
4
.
.
.
Select 1. Execute and press ENT, the screen
at right is displayed and scanning starts.
¾ To check the registered channels in the
channel group, select 2. User channel list
and press ENT.
¾ To change the scanning speed, select 3.
Scan speed (sec) and press ENT. The setting
range is 0.3 to 9.9 seconds, the same as
TEL/DSC/CW.
- Scanning can be done regardless of the squelch being set to open or close.
When pressing the PTT or keying the CW keyer, or when squelch is opened
after closing condition, scanning stops momentarily and the icon starts
blinking. In this case the scanning can be restarted by pressing ENT.
- To stop scanning, press the CANCEL key.
- When scanning to receive routine DSC calls, set the scan speed to 0.3
seconds within 6 channels.
Note: If too many channels are being scanned, it may not catch the reception.
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :OFF
6.CW bandwidth :Narrow
7.Scan
0.Back
5.4.7)Scan
No CH group name Type
01 JRC Tokyo TEL
02
03
04
05
06
07
08
Pacific ABC CW
5.4.7)Scan
No CH group name Type
01 JRC Tokyo TEL
02
03
04
05
06
07
08
Pacific ABC CW
1. Execute
2. User channel list
3. Scan speed (sec)
TEL DSC CW
3.0 0.3 3.0
Note
Note
Note
TEL
4357.0
-----.-
RX kHz
TX kHz
NonDST: +
DROBOS: +
EdtDST: +
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59 (EXT)
SIG
WKR scan bands:
2 4 6 8 12 16MHz
JRC Tokyo
U01- 001