Instruction Manual
3-33
●
Entering the respective items:
After selecting each item, press
to confirm the selection.
(1) Address: Use the numerical keys (
to
) to specify the address of the destination
station (coastal or ship station).
(2) Category
Telecommand-1: Use the
and
keys to select the items.
Telecommand-2
(3) Ship's position: Use the
and
keys to determine the direction, and then input the
ship's position using the numerical keys (
to
).
(4) Call TX/RX freq: Use the
and
keys to select one of the preset frequencies, or use
the numerical keys (
to
,and
) to specify a frequency directly.
(5) Other settings:
・"Work TX/RX freq": Use the numerical keys (
to
,and
) to specify a frequency
directly.
・Switching from "Ship's position" to "Work TX/RX freq": Press (FREQ).
・Switching from "Work TX/RX freq" to "Ship's position": Press (POS).
Set the "Work TX/RX freq" to a frequency in the same band as "Call TX/RX freq".
4. Press
.
The following screen is displayed and the message is transmitted.
When the transmission is completed, the following screen is displayed for a while, and the message is
saved. After that returns to the "MENU#1-EDIT&CALL" screen.
Refer to the example in "(6) ALL SHIPS CALL" for information on the DISTRESS RELAY procedure.
To store a message without sending it, press
(SAVE).
To discard the message and quit, press
(QUIT).
0 9
0
9
0 9 .
FUNC 6
FUNC 5
ENT
CALL
INDIVIDUAL CALL
Transmitting
TX frequency : 4,208.0 kHz
TX date&time : 06.Sep.2001(Thu) 01:30
INDIVIDUAL CALL
Send Completed
TX frequency
: 4,208.0 kHz
TX date&time : 06.Sep.2001(Thu) 01:30
FUNC
9FUNC
4
0 9 .
Note
Note