Manual

3-107
Dip switch setting for each equipment.
DIP switch setting
JSS-296(NCT-196N/NDZ-127J)
JSS-825D(NCT-620D)
NCT-196
NCT-196N
JSS-850
JUE-75C(NDZ-127C)
JSS-825NA/NC(NDZ-127N)
3.8.8 How to Attend to Error Detection
There are two types of errors. When an error is detected, a beep sounds, and the P.OUT lamp blinks 5 times.
(1) Paper discharge error
When the "out of paper" state is not detected, even though an 18 inch line feed procedure is performed, a paper
discharge error will result. The P.OUT lamp remains blinking until the error state is canceled.
When this happens, manually pull the paper out of the printer, or remove the paper automatically by using LF
or
FF
, then press ONLINE .
(2) Paper sending error
If the paper is not properly set, even though a 10 inch line feed procedure is performed, a paper sending error
results. In addition, if this error happens when the printing instruction is entered, the P.OUT
lamp remains blinking
until the error state is canceled.
When this happens, follow the procedure below.
Procedure
1. Press ONLINE switch.
The printer is set to an off-line state.
2. Press FF switch, set the paper, then press ONLINE .
The printer is set to an on-line state.
12345678
OFF
ON
DIP switch
12345678
OFF
ON
DIP switch
12345678
OFF
ON
DIP switch
Note