User Manual

- 78 -
3.10.2 Charging Device BC-3008 series
The battery charger BC-3008-series is exclusively used with the battery pack BP-3007-series.
When the battery pack is in the availability "0" state, charging will take about 2.5 hours.
(1) Procedure for using the charger
a) Mount the battery in the charger (see Figure 3-24-(1))
While pushing the battery pack against the charger, slide it in the direction indicated by the
arrow. Mounting of the battery pack is completed when it is pushed in until the shutter of the
charger is hidden.
b) Connect the AC cord to the charger
Connect the AC cable to the charger, and connect the AC cable plug to the socket outlet.
(See Figure 3-29-(2).) The CHARGE lamp (orange) on the charger will light indicating the
start of charging.
c) Completion of charging
When the CHARGE lamp goes off, the battery pack has been charged enough for practical
use. The battery pack will be fully charged if it is charged for another hour continuously after
the lamp goes off.
d) Removing the battery
When charging is finished, remove the battery pack sliding it in the opposite direction from
the mounting, and disconnect the AC cable plug from the socket outlet.
• Thoroughly read the charger instruction manual to use the battery charger
correctly and safely.
• Charge the battery pack in a place where the ambient temperature is 0 to 35 and the
humidity is 45 to 90%.
• After using the battery charger, be sure to disconnect it from the socket outlet. Dismount the
battery pack from the charger within 24 hours after it has been charged.
• Store the battery pack in a cool location to ensure the longevity of the battery. It is
recommended to charge the battery in an area with a temperature between +10 and +30 °C.
Figure 3-29 Battery Charger
Charge lamp
Shutter
Notes
Remarks