User's Manual

Chapter 2



OPERATIONS

2.14



FUNCTION KEY SETTINGS

2-119

INSTRUCTION MANUAL

 From "PRF" to "Initialize"



z PRF

Operate the same way for the scanner settings in Adjust Menu.

For details of operations, see Section "4.6 SCANNER" of INSTALLATION MANUAL.

z Antenna Height

y Changes the antenna height setting.

y The STC/FTC curve is changed.

Default: Activates the general signal processing mode.

-5m: Set the antenna height under 5 m.

5-10m: Set the antenna height 5m to 10m.

10-20m: Set the antenna height 10 m to 20 m.

20m-: Set the antenna height over 20 m.

z Save Present State

Registers the currently used settings as function settings.

z Set Mode Default

Sets the initial value of a selected function setting mode. Select this item to change the

current function mode to the initial value.

z Initialize

Sets the function settings to the factory-set values. Select this item to change all the

function settings to the factory-set values.