User's Manual

7.1 SETTINGS AT INSTALLATION

7─10

yyy

yyyy

GPS position :

If you wish to connect multiple GPS systems to a COM port and select a GPS position to be used, select it

through the receiving port setting of the GPS you wish to use.

Reference: Section 7.3.1.2 “Reception Port Setting (RX Port)”

Radar antenna position :

The radar antenna position changes as the antenna mode is switched between the master mode and the slave

mode by the simplified inter-switch.

CCRP position :

Only one position can be set.

If CCRP1 is outside the display area, ANT1 or ANT2 becomes the CCRP.

ANT1: Radar antenna position (MASTER)

ANT2: Radar antenna position (SLAVE)

CCRP is changed on the condition as following.

・ Radar antenna position is outside of the off center limit.

・ The CCRP position is outside of PPI.

This condition occurs with for example off center, true motion, turn of own ship, etc.