User's Manual
3.9 APPLIED OPERATIONS
3─104
3
y
y y
3.9.2 Set Radar Trails (RADAR Trails Setting)
This function enables the setting of detail information about radar trails processing.
Procedure 1 Press [RADAR MENU] key twice.
Press [7] key.
Alternatively, hold down the [TRAILS]
key until the menu appears.
The RADAR Tails Setting Menu will appear.
Detail information about radar trails processing
can be set by changing the settings of the menu
items.
Note:
After the settings for radar trails processing are changed,
targets’ trails may not be displayed or trails may be plotted
with unwanted waves. Thus, do not make a significant
change in the settings.
[1] Trails Interval
• Set the trail intervals at which radar trails are displayed.
• Selection items of trail intervals change depending on the setting of maximum value of radar trail
display time.
• The Multi-function control is also available for setting.
• For the decision branches of trail interval, see Section 3.5.10 “Display Radar Trails (Other Ships'
Trails)”.
[2] Trails Mode
• Set the radar trail display mode.
• Each time the button is pressed, you can switch between True and Relative.
• For details on the trail mode, see “Changing Motion Mode of Trails (Trails mode)” in 3.5.10 “Display
Radar Trails (Other Ships' Trails).”
[3] Trails REF Level
• Select a radar video level required for plotting radar trails.
• The radar video level increases in order of LEVEL1 → LEVEL2 → LEVEL3 →
LEVEL4 .
• To plot radar trails with unwanted waves, change to a higher level.
• To thin radar trails, change to a higher level.
• If radar trails are plotted in snatches, change to a lower level.