Specifications

FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The SmartCard + NFC Reader Module is designed to comply with the FCC statement. FCC ID is
2AWLWAP-SCRNFCX-XX. The host system using SmartCard + NFC Reader Module should have label
indicated it contain modular’s FCC ID :2AWLWAP-SCRNFCX-XX . This radio module must not installed
to colocate and operating simultaneously with other radios in host system additional testing and equipment
authorization may be required to operating simultaneously with other radio.
The SmartCard + NFC Reader Module has integrated antenna on the PCB, users do not need to install
additional antenna.
The SmartCard + NFC Reader Module and its antenna must not be co-located or operating in conjunction
with any other transmitter or antenna within a host device.
Notice to OEM integrator
The SmartCard + NFC Reader Module is deaigned for a compact PCB design .It should be installed and
operated with laptop.
OEM can install the module into the host through the module's USB port, but it should be noted that the
module's swipe port needs to be correctly installed on the surface to ensure the normal operation of the NFC
function.
The end user manual shall include all required regulatory information/warning as show in this manual. The
OEM integrator is responsible for testing their end-product for any additional compliance requirements
required with this module installed.
The device must be professionally installed
The intended use is generally not for the general public.lt is generally for industry/commercial use. The
connector is within the transmitter enclosure and can only be accessed by disassembly of the transmitter that
is not nomally required, the user has no access to the connector.Installation must be controlled. Installation
requires special training
This device complies with Part 15, Subpart C, Section 15.225 of the FCC Rules.