User's Manual

You can select the Main Console in Alert or Chime or OFF mode by switching the mode switch to
“Alert” or “Chime” or “OFF” position.
MUTE
When a sensor is triggered for a longer period of time, you may stop the beeping by pressing the
mute button. The Main Console will beep again if it receives another signal.
ALARM MODE
The Main Console provides the alarm feature, instant alarm and delay alarm.
To arm the Main Console to Instant Alarm:
1. Press the current MPIN [1111].
2. Press and hold the [Arm] button.
3. While the Armed LED turn on and emit a long beep, you may release the [Arm] button.
If any of the sensors are activated, the alarm is sounded instantly for 3 minutes.
To arm the Main Console to Delay Alarm:
1. Press the current MPIN [1111].
2. Press the [Arm] button twice.
3. The Armed LED will flash and emit the beeps of about 60 seconds which gives you 60
seconds to leave the premises before the system is activated.
4. Upon re-entering the premises, for example opening the front door in zone 1, you will
have 30 seconds till the alarm sounds.
Disarm the Main Console:
1. Press the current MPIN [1111].
2. The Armed LED will off and emit the continuous beeps for awhile.
MPIN
To access the alarm sequences is controlled by the Master Personal Identification Number
(MPIN). To operate the arm sequences in Main Console, enter the current MPIN [factory default
1111].
To change your MPIN:
1. Press and hold both the Learn button and Arm button, release the buttons until it has a
long beep and the Power LED keep flashing.
2. Enter the current MPIN [factory default 1111].
3. Enter the new MPIN [e.g. 4321].
4. Enter the new MPIN [4321] again.
5. It emits a long beep and the Power LED stay on means the system accepts the new
MPIN.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,