User Manual
40529 V3
1/1/19
MADE IN TAIWAN
GE is a trademark of General Electric Company and is under
license by Jasco Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime warranty.
Visit www.byjasco.com for warranty details.
Questions? Contact our U.S.-based Consumer Care at
1-800-654-8483 between 7AM -8PM CST.
ANTENNA HELPFUL TIPS
Maximize the number of channels you receive by testing
the antenna in several different locations and orientations.
Use the meter to determine the best position at your
location for the antenna. Run a channel scan on your TV
after finding the best position. Refer to the instruction
manual that came with your TV if you are not sure how to
run a channel scan. If you have minor picture break-up with
a specific channel, slightly rotating the antenna may help.
Anytime the antenna is repositioned, run a channel scan
again to ensure the best recognition.
Position or mount the antenna as high as possible or near
a window for best performance.
Visit www.antennaweb.org or www.dtv.gov for DTV
reception maps to determine the available television
stations and location of the broadcast towers in your area.
For further assistance, call 1-800-654-8483 for
technical support.
Special note: The top row of blue LEDs is the most
important. It is always better to have more blue LEDs lit
on the top row than on the bottom row. For example, an
antenna position with 2 LEDs lit on the top row as shown
below is better than a position with only 1 blue LED lit on the
top row and 5 blue LEDs lit on the bottom row.
STRONGER SIGNAL
WEAKER SIGNAL
For further information on the signal meter, refer to the
HOW TO READ SIGNAL FINDER METER section.
After you find the best position for your antenna, you can
turn off the signal meter by pressing the ON/OFF button
beside the meter. You can turn the signal meter on and
check your signal level at any time by pressing this button.
ON/OFF
6. SCAN FOR CHANNELS ON YOUR TV: This step is very
important. Your TV will NOT receive signals from the
antenna without doing a channel scan. See your TV’s
menu to run a channel scan. You can also refer to the TV
instruction manual for detailed information.
Contact us at 1-800-654-8483 if you need assistance.
Please note: For reception, all components must be
connected and/or plugged in.
HOW TO READ SIGNAL METER:
The signal finder meter contains 2 rows of LEDs to
display signal strength
• 3 blue LEDs on the top row
• 5 blue LEDs on the bottom row
Weak signal: 0 top LED lit, 0 to 5 bottom LEDs lit
Low signal: 1 top LED lit, 0 to 5 bottom LEDs lit
Good signal: 2 top LEDs lit, 0 to 5 bottom LEDs lit
Strong signal: 3 top LEDs lit, 0 to 5 bottom LEDs lit