Instruction Manual

FCC Statement
This device complies with Part 15 of
the FCC rules. Operation is subject to
the following two conditions: (1) this
device may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
FCC Note: The manufacturer is not
responsible for any radio or TV
interference caused by unauthorized
modifications to the equipment. Such
modifications could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
GE is a trademark of General Electric Company and is used under license to Jasco Products Company LLC,
10 E. Memorial Road, Oklahoma City, OK 73114. www.jascoproducts.com
45254 rev. 5/23/11
Risk of electric shock
- Turn power off before servicing—see
instructions.
- Properly ground fixture.
- Ensure that no bare wires are exposed
outside the electrical connections.
Risk of injury
- LED light output is strong enough to
injure human eyes. Precautions must
be be taken to prevent looking directly
at the LEDs with unaided eyes for more
than a few seconds.
- Some metal parts in the fixture may
have sharp edges. To prevent cuts and
scrapes, wear gloves when handling
the parts.
- Account for small parts and destroy
packing material, as these may be
hazardous to children.
Risk of fire
- Minimum 90º C supply conductors
No serviceable parts
Non-replaceable LEDs
WARNING