Wireless Optical Mouse Instruction Manual HO97990 / 98150 For technical support, contact Jasco at 1-800-654-8483 or www.jascoproducts.
TABLE OF CONTENTS FEATURE DESCRIPTIONS ------------------------------------------- 3 PACKAGE CONTENTS ------------------------------------------------ 3 SYSTEM REQUIREMENTS ------------------------------------------- 3 CONNECTING YOUR MOUSE --------------------------------------- 4 POWER SAVING FEATURES ---------------------------------------- 5 TROUBLESHOOTING -------------------------------------------------- 6 5 YEAR LIMITED WARRANTY--------------------------------------- 8 FCC STATEMENT ---------------
FEATURE DESCRIPTIONS • • • • • Eliminates the clutter of tangled cords Provides pinpoint precision on most surfaces and won’t wear out Goes to sleep when idle for a long time to extend battery life Battery Low LED illuminates when the battery is low Compatible with any USB port PACKAGE CONTENTS • • • • Wireless Optical Mouse USB Receiver Two AA Batteries User’s Manual SYSTEM REQUIREMENTS • • • • • • Pentium 133 MHz or higher processor Windows® or Mac compatible For Windows® 98 SE: minimum of 32 MB of R
CONNECTING YOUR MOUSE 1. Disconnect the existing mouse. 2. Connect the receiver’s USB plug to the USB Port on your computer. 3. Place the receiver 8” (20cm) from any other electronic device such as your computer and monitor. 4. Install the included 2 AA batteries into the battery compartment located on the bottom of your mouse. Position the batteries according to the diagram in the battery compartment. Low Battery LED Link Button On / Off Switch 2 AA Batteries 5.
Note: Optical mice do not work well on glass or highly reflective surfaces. If your mouse does not work properly, try a different surface such as a plain white piece of paper. POWER SAVING FEATURES 1. 2. 3. After a period of inactivity, the Wireless Optical Mouse goes into sleep mode to save batteries. To wake the mouse, press any mouse button. The low battery LED located on the bottom of the mouse will illuminate when the batteries are low and need to be changed.
TROUBLESHOOTING 1. Linking the mouse ¾ Press the Link button on the bottom of your receiver with a pen or paper clip. Receiver Link Button ¾ Mouse Link Button On / Off Switch Being careful not to shine the light in your eyes, use a pen or paper clip to press the Link button on the bottom of your Wireless Optical Mouse. Move the mouse to ensure connection. 2. Mouse Does Not Respond After a period of inactivity, the mouse goes into sleep mode to save batteries. To wake the mouse, press any mouse button.
Mouse Does Not Respond (Continued) ¾ Make sure you have installed all Windows® updates and patches for your OS. Visit www.microsoft.com ¾ Optical mice do not work well on glass or highly reflective surfaces. Try using your mouse on a different surface such as a plain white piece of paper. ¾ Turn off your computer. Unplug the receiver from your computer. Wait 20 seconds. Plug the receiver into your computer. Turn your computer on. You may need to re-link the mouse using Troubleshooting step 1. 3.
5 YEAR LIMITED WARRANTY Jasco Products Company warrants this product to be free from manufacturing defects for a period of five years from the original date of consumer purchase. This warranty is limited to the repair or replacement of this product only and does not extend to consequential or incidental damage to other products that may be used with this unit. This warranty is in lieu of all other warranties express or implied.
FCC STATEMENT Notice: Federal Communications Commission (FCC) requirements, Part 15 This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
CAUTION: Any changes of modifications not expressly approved by the grantee of this device could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
