User Manual

Command Line Interface
Special Commands
28 www.javad.com
The response of command without Parameter Name indicates all values:
RATE =0
BITS =8
PARITY =NONE
FLOW =NONE
DTR =0
RS =RS232
DATATX =UART
DATARX =UART, BT
3.2. MPORT
The MPORT is an object that responsible for maintenance serial port interface configurations such as data
rate and number of bits in a byte.
MPORT [Parameter Name] [Parameters List] [/?]
Note: JAVAD GNSS radio modem’s does not support data flow and parity on the maintenance serial port.The
radio modem with none-dedicated maintenance serial port must keep CTS line always active in MPORT
mode (DP/MP is low).
4. Special Commands
4.1. BOOT
The factory software image and default configuration is set for the new unit. The BOOT command is
intended to reboot the unit using specified software image and selected configuration.
BOOT IMAGE
DATARX 0 - UART, a default setting
1 - USB
2 - BT
Parameter Name Parameter List
RATE 0 – Auto.
1 – 1200 baud
2 – 2400 baud
3 – 4800 baud
4 – 9600 baud
5 – 14400 baud
6 – 19200 baud
7 – 38400 baud
8 – 57600 baud
9 – 115200 baud, a default setting
Parameter Name Parameter List