User Manual
Table Of Contents
- HPT204BT*
- Table of Contents
- Preface
- FCC Class A Compliance
- Canadian Emissions Labeling Requirements
- Industry Canada
- WEEE Directive
- Introduction
- Configuration
- Command Line Interface
- Specifications
- VHF Radio Usage
- Safety Warnings
- Warranty Terms
Command Line Interface
Diagnostics and Identification Commands
31www.javad.com
STATE [Parameter Name] [Parameters List] [/?]
The STATE command without Parameter Name indicates all values as shown below:
RSSI =-141 dBm
BER =0E-0
FREQ =235.000000 MHz
CHAN =-4
TEMP =32
SYNC =0
MODE =FIXED
VHPA =11.75 V
BT =ON
Parameter
Name
Parameter List
RSSI -15 to -137 dBm - Indicates the Receive Signal Strength in dBm
BER 0 to 9.9E-3 - Indicates the BER level
FREQ 215.000000 to 255.000000 MHz - Displays the central frequency of the operating
channel
TEMP -30.C to 100.C. Displays the temperate inside of enclosure.
SYNC 0 - if link is not established yet
1 - indicates the link established
MODE AUTO/FHOP/FIXED
VHPA VCC V
BT ON/OFF