User's Manual

Configuration
Connecting HPT404BT and TRIUMPH-1
Connecting through Bluetooth®
18 www.javad.com
2.4.3. Connecting through Bluetooth
®
Note: Do not forget to attach the Bluetooth
®
antenna to Bluetooth antenna connector on the back panel of the
modem.
The HPT404BT modem contains Bluetooth
®
wireless technology that allows synchronization between
the modem and any other external device that supports Bluetooth
®
wireless technology; for example, an
IPAQ, or a computer with USB-to-Bluetooth
®
adapter or PCMCA-to-Bluetooth
®
adapter installed, etc.
HPT404BT and external device connection procedure varies slightly depending on the type of external
device used. In general, the connection procedure is as follows:
Note: Refer to your Bluetooth
®
-enabled external device documentation for more detailed connection
information.
1. Turn on a Bluetooth
®
-enabled external device and your receiver. The default external device
mode is Master; the modem’s Bluetooth
®
module mode is Slave.
2. Instruct the external device (Master) to search for the modem (Slave).
3. Once the Master device detects the modem, use the procedure described in the external device’s
documentation to connect it with the modem.
2.5. Connecting HPT404BT and TRIUMPH-1
Connect the external HPT404BT UHF radio to receiver’s port B with cable Accessory Data-Ser cable,
ODU-7/DB15/SAE (6 ft./1,8m), p/n14-578110-02.
Figure 2-4. Connecting HPT404BT and TRIUMPH-1
Once you have established a connection between the modem and the TRIUMPH-1, you will be able to:
• Configure the modem and its components through receiver;
• Send commands to the modem trough receiver;
• Use ModemVU to load new firmware to the modem
• Transmit/receive GNSS data.
+
+