Integration Manual

Page 9 / 19
8 IC STATEMENT
The OEM integrators are responsible for ensuring that the end-user has no manual instructions to remove or install
module.
These following instructions/statements shall be reported on the User Manual:
This radio transmitter (3393A-S5) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum permissible gain
and required antenna impedance for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the maximum gain indicated for that type,
are strictly prohibited for use with this device.
Le présent émetteur radio (3393A-S5) a été approuvé par Industrie
Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain
admissible maximal et l'impédance requise pour chaque type d'antenne. Les types
d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal
indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
This device complies with ISED and FCC radiation exposure limits set forth for general
population. This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Le présent appareil est conforme aux niveaux limites d’exigences d’exposition RF aux
personnes définies par ISDE et FCC. L’appareil ne doit pas être installé à proximité ou être
utilisé en conjonction avec une autre antenne ou un autre émetteur.
The radio module must be labelled as follows:
FCC ID: OQMS5
Moreover, the host equipment must be labelled as follows:
Contains FCC ID: OQMS5, Model S5, IC: 3393A-S5
Warning:
This modular is used exclusively by JAY Electronique. This module and the antennas must be professionally
installed.