User's Manual

UDEE / UDRE - 332170A revision02 - 17 -FrEnDePRELIMINARY
électronique
NB : if this procedure is not observed the transmitter indicates an error with the red and green
indicator light :
- «3 flashes error type» (The green and red leds flash 3 times, mark a break, then flash 3
times etc.) : resume identity code copy procedure described in § 3.5.3.
- «5 flashes error type» (The green and red leds flash 5 times, mark a break, then flash 5
times etc.) : Stop or startup error (make sure that the pack battery is correctly inserted in the
transmitter housing and resume the radio remote control startup procedure).
3.3- First radio remote control startup
See startup block diagram on next page
1- Switch ON the UDRE receiver.
2- Plug the UDB2 battery pack into UDEE transmitter housing.
(Take care that UDB2 battery pack is loaded and is well
connected to UDEE transmitter back.)
3- Install the electronic key on the transmitter or take care of
its presence on UDE transmitter.
4- Copy electronic key identity code to UDEE transmitter
memory, see procedure on § 3.5.4.
5- Unlock the transmitter stop palmswitch button.
6- Press the green «On/Horn» button until the receiver is
started up (safety relays are activated).
7- Use the radio remote control to control the equipment.
UDEE
transmitter
UDB2
battery pack
electronic
key
To stop the radio remote control :
press the UDEE transmitter stop palmswitch button.