User's Manual

UDEE / UDRE - 332170A revision02 - 23 -FrEnDePRELIMINARY
1- Switch off the UDRE receiver
2- Insert the electronic key in the UDEE transmitter unit.
3- While holding buttons n°2 and n°3 pressed, unlock the transmitter emergency stop button (fig.
1): the 2 indicator lights on the transmitter will flash rapidly.
4- Press the "On/Horn" button to perform automatic programming of the identity code: the two
indicator lights on the transmitter go off (fig. 2).
5- The "identity code" information is copied from the electronic key to the transmitter memory (fig.
3).
6- Exit the programming mode by pressing the stop palmswitch button (fig.4).
Reminder :
To use the UDEE/UDRE radio remote control system, the identity code contained in the transmitter
memory must match the identity code in the electronic key which is itself identical to that of the
receiver.
If a maintenance transmitter is used or if you change electronic key, the information contained in the
electronic key must be copied in the UDEE transmitter memory.
Conditions for using this procedure :
The configuration of the backup transmitter buttons must be identical to that described in the
electronic key (or the original transmitter).
DATA
3.5.4 Procedure: "Copying electronic key identity code to UDEE transmitter
memory"
Apply this procedure when :
- starting the radio remote control for the first time
- using a maintenance transmitter
- changing the electronic key
Fig.3
Fig.1
Fig.2 Fig.4
electronic key
memory
UDE
transmitter
memory