User's Manual

UDEE / UDRE - 332170A revision02 - 29 -FrEnDePRELIMINARY
 Each "BPDV" button type pair is assigned either 3 relays (2 movement relays and a third relay
for high speed), or 4 relays. This information is contained in the UDRE receiver product
reference data (see § «product identification»).
1st button of
interlocked pair
1nd button of
interlocked pair
Acronym
Button n°1 Button n°2 B1-B2
*
Button n°1 Button n°3 B1-B3
Button n°1 Button n°4 B1-B4
Button n°2 Button n°3 B2-B3
Button n°2 Button n°4 B2-B4
Button n°3 Button n°4 B3-B4
*
Button n°3 Button n°5 B3-B5
Button n°4 Button n°6 B4-B6
Button n°5 Button n°6 B5-B6
*
Button n°7 Button n°8 B7-B8
Button n°7 Button n°10 B7-B10
Button n°8 Button n°9 B8-B9
Button n°9 Button n°10 B9-B10
5.1- Function button interlockings
The following function button interlocking configurations are possible:
*
*
*
n°1 n°2
n°7
n°8
n°9
n°10
n°5
n°6
n°3
n°4
(UDEE transmitter front panel view)
*= Standard interlocking configurations defined in sales reference
for UDRE receiver (see §2.3.2 «product identification»).
For each of the desired interlocking configurations, simultaneous action on the two buttons will result
in three operating modes which depend on the programs defined :
- program «
1» : By pressing the 2 button pair, the two commands are deactivated (corresponding
relays set to OFF).
- program «
2» : The first button of the interlocked pair has priority.
(ex.: button n°1 and button n°2 interlocked: when these two buttons are pressed
simultaneously, only button n°1 is acknowledged).
- program «3» : The 2nd button of the interlocked pair has priority.
(ex.: button n°2 and button n°4 interlocked: when these two buttons are pressed
simultaneously, only button n°4 is acknowledged).
- program «X» : special (according to a customization data sheet).
For non-standard "button-relay" configurations, be sure to properly fill in the configuration
sheet located in the UDRE cover.
5.2- Correspondence between «transmitter function buttons
and receiver relays»
In its standard configuration, the "buttons-relays" are assigned naturally by the increasing
order of the button numbers and relay numbers :
))
))
)
))
))
)
5- Technical data