User's Manual

UDEE / UDRE - 332170A revision02 - 31 -FrEnDePRELIMINARY
5.3.2- Electronic key
The electronic key used on the UDEE/UDRE radio remote control system has a dual function :
- It enables start-up of the transmitter by limiting access to the remote control to trained and
authorized persons only.
- It contains all the information required for operation of the product, including :
- the system identity code
- the last frequency programmed *
- the "dead man" function duration *
- the transmitter button configuration
- the button mask (special function)
- and the option register (micro-speed etc...)
* = reprogrammable by a trained operator, see §3.5
When the key is removed, it prevents unauthorized use of the transmitter. For this reason, it
should be removed (like the battery pack) when the remote control is put away.
Preferably, the electronic key should be removed after pressing the stop palmswitch button.
Removal of the key before the stop palmswitch button button is pressed will result in a fault
indication (2 flashes) and passive shutdown of the receiver.
If necessary, it can be used to stop the system.
The transmitter cannot be started up without its electronic key.
))
))
)
Identity code contained
in electronic key
Identity code contained
in transmitter UDEE
The transmitter UDEE also has an internal memory containing an identity code.
- If identity code of the electronic key matches the identity code stored in the UDEE, the
transmitter can be started up.
- If the identity code of the electronic key and that of the UDEE do not match, the transmitter
indicates the problem by its two indicator lights (3 flashes). In this case, perform the
programming procedure described in §3.5.4.
UDEE can be started up provided :
Transmitter identity code
=
Electronic key identity code
In the event of a transmitter failure :
You can recover the electronic key and connect it on a maintenance transmitter (button
configuration should be the same as that of the failed transmitter, otherwise, buttons that
are different will be ineffective).
To perform this operation, you must reprogram the key identity code in the new transmitter
UDEE as described in the procedure in §3.5.4.
if your electronic key is lost :
You can order another electronic key (reference UDWE22X) making sure to specify the
following information on the order :
- The unique 6-digit number of the old key (written on the cover page of this manual
when you unpacked your product).
or, if you do not have key number :
- the associated receiver identity code (on receiver descriptive label) and transmitter
button configuration
This information will allow you to receive an electronic key identical to the old one containing
all the parameters indicated above for your radio remote control.
électronique