Manual

WWW.JAYS-AUDIO.COM Page 2 of 10
QUICK START GUIDE
1. After receiving the CDT, please do not rush to power it up. First, check the physical
appearance of any damage may be caused by shipping.
2. Slide the top loading lid open and remove the protection foams completely.
3. Insert a disc, put on disc clamp, close the slider lid. You should hear a click sound where
the slider lid limit switch triggered.
4. Plug in the power cord and turn on the rear power switch.
5. After about 5 seconds of spinning the disc, the CDT automatically enters the power-on
state, and the OLED display flashes “READ” indicating that the disk information is being
read.
6. After the disc information is correctly retrieved, the disc information’s will be displayed.
For example, "18 84:18". At this point, the CDT is in normal operation.
7. Connects digital output to the external DAC for playback.
TIPS
1. The CDT will work at its best quality after an hour of warming up.
2. Power On / Off
 Turn on/off the power switch at the rear panel to turn on/off the unit.
 It is safe to leave the power switch on 24/7
3. When not in use for a long period of time, it is recommended to switch off the main
power switch to save the earth.
4. The CDT needs about 400 hours to burn in.