Operation Manual

4. Loading Slides
Hold up the slide toward the light. Face the
trademark side of the slide away from you. Look
through the slide and it should appear normally
(not a mirror image).
Now turn the slide so the image is upside down
while looking at the same side.
Open the slide holder at the marked spot on
the top.
With the slide holder laid open place the slide
into recessed area in the holder- the slide
should fit perfectly.
Note: Handle slides with care. Any dust scratches or fingerprints will show up
on your saved images. If possible use cotton gloves when handling slides. It
is recommended to use compressed air to remove any dust on the slides.
This is not included with the film scanner but can be purchased from an office
supply or electronics retailer.
Close the slide holder and press the edges so
that it locks in place.
Hold it in the position as shown in the film
scanner.
Insert the Slide Holder into the slot on the
right side of the film scanner as shown.