Owner's Manual

23
TROUBLESHOOTING
If your buds are not responding, connect the charge clip and USB cable to a power source. This will turn your
buds off and perform a soft reset.
If this does not resolve your problem we recommend to reset your buds to their original factory Settings.
NOTE: Once your buds have been reset you will have to pair it again to your devices. Select “FORGET” or “REMOVE”
Jaybird X3 from your device’s Bluetooth menu. Follow the pairing instructions on page 5-6 to repair your devices.
Put your buds in pairing
mode. Turn the buds off,
then press and hold the
Power Button for more
than 4 sec until you see
alternating red/green LED.
1
While the LED is
flashing red / green
double press the
Power Button.
2
The LED will
turn orange
and your buds
will turn off.
3