Operation Manual

38
TROUBLESHOOTING
1. To reset your buds to their original factory
settings put your buds in pairing mode by turning
the buds off then push and hold the
center button for more than 4 sec until you see
alternating red/green LED.
If your buds are not responding, connect the charging
clip and USB cable to a power source. This will turn
your buds off and perform a soft reset.
2. While the LED is flashing red / green
double tap the center button. Upon
successful factory reset, the LED turns
orange and your buds turns off.
LED
NOTE: Once your buds have been reset and you
power on they will automatically go into pairing mode.
Select “Forget” or “Remove” Jaybird Freedom from
your device’s Bluetooth menu and pair again.
FACTORY RESET
RESET