--- BBC-SPRTKT --(Cable Supported Tunnel Kit) Installation Instructions Call Jaypro Sports Equipment at 1-800-243-0533 during regular business hours for technical support. www.jaypro.
JAYPRO SPORTS BBC-SPRTKT, INDOOR CABLE SUPPORTED BATTING TUNNEL KIT IMPORTANT NOTICE: 1) DO NOT SET CAGE OR NET TOO CLOSE TO WALLS, COLUMNS, CEILINGS OR ANY SOLID OBJECT WHERE BALLS CAN STRIKE AND BOUND BACK. CAGE OR NET SHOULD BE AT LEAST 4 FEET FROM ALL BYSTANDERS, CEILINGS, WALLS OR SOLID OBJECTS. 2) SPECTATORS MUST NOT STAND IN BACK OR NEAR SIDES OF CAGE OR NET WHILE BEING USED FOR BATTING PRACTICE. 3) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE HAZARDOUS AND RESULT IN INJURY.
ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: (1) Nut Driver Set (1) Box Wrench Set (1) Electric drill w/ Phillips head (1) Bolt Cutters (1 or 2) 16 FT Stepladder(s) Unpack all parts and check against parts list to ensure that all have been included. Inspect all parts for damage. Report any damages to the trucking company. ITEM 1 2 3 4 5 6 7 8 9 10 Rev-B DESCRIPTION 1/4" GALVANIZED AIRCRAFT CABLE x 100 FT 1/2" x 6" STEEL EYEBOLTS, ZP 1/2" x 12" GALV.
1) Make up one end of each of the three cables, as shown in Figure 1. Tighten the cable clamps using a nut driver. Figure 1: Assemble End Loops 2) Make up the other end of each cable leaving the cable clamps hand tight, as the overall length may need to be adjusted. 3) Mark the location of the cable anchor as shown in the diagram below. The spacing and height dimensions shown are for a 12’ wide x 12’ high net. Adjust dimensions accordingly for different width and height nets.
4) Attach the fixed ends of the three cables to the building structure, as shown. 9/16” holes will need to be drilled to accommodate the 1/2” eyebolts. Note if optional wall mounting kit (BBC-WLKT) is purchased; please see installation instructions that come with it.
5) Attach the adjustment end of the three cables to the building structure as shown. Figure 5: Standard Building Attachment On Adjustment End 6) Extend the turnbuckles to their maximum length for each cable. Loosen the two cable clamps and remove as much slack from the cable as possible. Using the turnbuckles tighten each cable. Roll out net under the suspended cables, spreading it out flat. Center the net between the end cables.
) Attach the net to the cables using the snap hooks place every 12”. Place the snap hooks on the three binding cords along the outer edge and mid line. Figure 6: Attach Net To Cable 8) Adjust the cables using the turnbuckles (see figure 5) as needed to minimize sag. Caution: over tightening the cables may results in damage to the wall or support structure.
OPTIONAL KITS AND HARDWARE: MODEL #: BBC-WLKT WALL MOUNTING KIT: (QTY: 6) Wood stringers and mounting plates for attaching to CMU block and concrete walls. MODEL #: BBC-CSKT CABLE SUSPENSION KIT: 1/8” Cable and associated hardware to allow support cables to be raised higher for added clearance. MODEL #: BBC-SCKT CABLE SPREADER TUBE KIT: (QTY: 12) 3/4" conduit tube and associated hardware for maintaining the maximum net width.