User manual

WHDV-5008 EN/1501.V01
EN
4
AFTER USING VIDEO CAMERA IN WATER
 Be sure to come ashore within 30 minutes after going underwater, this will maintain the appearance, quality and water
resistance of the video camera.
 After taking pictures underwater, clean the video camera in a bucket of water without salt. Ensure that the battery cover
/jacks cover is closed; then soak the video camera in the bucket of water for about 10 minutes. After 10 minutes, wipe
the video camera and the lens dry with absorbent cotton. Place the camera in a well-ventilated cool place to dry
naturally (do not place under direct sunlight or exposed areas). Be sure to wait until the video camera is completely dry
before opening the battery cover /jacks cover (open the cover while holding absorbent cotton to dry off water or clean
other impurities around the cover).
 Wipe off water drops on the video camera and the lens with a soft lint-free cloth (to avoid fiber) and place it in a
well-ventilated place to dry. The battery cover / jacks cover can be opened only after dry to prevent water from entering
the camera when opening.
 Before you open the battery cover /jacks cover, always wipe off water drops inside the cover. Note that it should face
down when opening.
NOTES ON MAINTENANCE
 Be sure to wipe any dirt or sand off the waterproof sealing material or its contraction surface. Dirt or sand may scratch
the material or the surface, making the video camera less resistant to water.
 Do not use any soapy water, mild detergents, alcohol or similar liquids to clean the video camera. They may make the
video camera less resistant to water.
 The waterproof of sealing material is replaceable at cost. The material should be replaced once a year to maintain the
video camera water resistance.
 If water accidentally enters the video camera or any problem occurs when it is in water, please get out of water
immediately and take proper actions. Dry the video camera and send it to repair.