Instruction Manual
OFF / ON BUTTON
REMOTE CONTROL LED LIGHT
HOW T PLAY
REMOT CNTROL PAIRNG
Turn the vehicle ON, then turn the transmitter controller ON within 30
seconds.*
*Do not press any buttons or switches on the controller while pairing, this may cause
interference.
The LED light on controller will start blinking.
Once the pairing is successful, the LED light on controller will stop blinking
and stay on.
If pairing is unsuccessful, turn the vehicle and controller OFF and try again.
NOTE: The vehicle will enter sleep mode after approximately 2 minutes of
inactivity. If the vehicle enters sleep mode, turn the vehicle and controller
o, then back on to continue operating with full capabilities.
1
2
3
4
5
Switch mode from TRY ME to ON at the bottom of the Mudap for full features.
Do not operate your vehicle on the street or on wet surfaces.
For best results, operate on smooth surfaces and avoid water and other liquids.
ADJUST ERING ALINMET
If the vehicle doesn't move forward in a straight direction,
adjust the steering alignment lever on the underside of the
vehicle.
FIGURE PLACEMNT
Front of Cab opens to allow easy gure placement.
SOUND ACTIVON
Collision sounds activate by pressing
front bumper.
LIGHT ACIVTON
While turned ON, Mudap lights will
remain illuminated.
ON / OFF / TRY ME BUTTON
ON OFF TRY ME
STEERING
ALIGNMENT LEVER
BATERY INSTALION STRUCIONS
ADULT INSALTION REQUID
Move the switch at the bottom of
the Mudap to the OFF mode.
Use a Phillips Head screwdriver (not
included) to remove the cover.
1
Remove the old batteries and insert the
new (6 X 1.5V AA Size (LR6)) batteries with
the correct polarity indicated inside the box.
Screw the cover back in.
2
Move the switch to the ON mode to
activate all play features of the Mudap.
Move the switch to the OFF mode when
not in use to help save battery life.
3
ON / OFF / TRY ME BUTTON
BATTERY COMPARTMENT
ON OFF TRY ME
ON / OFF / TRY ME BUTTON
BATTERY COMPARTMENT
ON OFF TRY ME
ON OFF TRY ME
BATTERY
COMPARTMENT
MUDFLAP
BATTERY COMPARTMENT
REMOT CNTROL
Move the switch at the bottom of the
Remote Control to the OFF mode.
Use a Phillips Head screwdriver (not
included) to remove the cover.
1
REMOTE CONTROL FRONT
REMOTE CONTROL BACK
OFF / ON BUTTON
Move the switch to the ON mode to activate
all play features of the Mudap.
Move the switch to the OFF mode when not
in use to help save battery life.
3
REMOTE CONTROL FRONT
REMOTE CONTROL BACK
OFF / ON BUTTON
BATTERY COMPARTMENT
Remove the old batteries and insert the new
(2 X 1.5V AAA Size (LR03)) batteries (not included)
with the correct polarity indicated inside the box.
Screw the cover back in.
2
REMOTE CONTROL BACK
BATTERY COMPARTMENT
RANGE OF PLAY: approx. 80 feet (24 meters).
CONTROLLER FREQUENCY BAND : 2410 MHz - 2473 MHz, MAXIMUM POWER : 0.457mW
RECEIVER FREQUENCY BAND : 2410 MHz - 2473 MHz, MAXIMUM POWER : 0.120mW
2 X 1.5 V AA (R6)