Instruction Manual

ManualsBrandsJBA ManualsCar1685SJT

Installation Instructions

and Warranty Information

Part # 1685S 2011-2014 Mustang 5.0

Read all instructions carefully before attempting installation.

Rev 2 2-28-13 DSL

Corporate Ofce: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 • FAX 909.599.6424

CARB EO # D-57-27

Summary of content (5 pages)

PAGE 1
Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 • FAX 909.599.6424 Installation Instructions and Warranty Information Part # 1685S 2011-2014 Mustang 5.0 CARB EO # D-57-27 Read all instructions carefully before attempting installation.
PAGE 2
PerTronix© thanks you for choosing JBA HEADERS, the best fitting, highest quality header on the market. In order to realize the full potential of our good fit, please read and understand these instructions completely prior to starting work. Check to make sure you received the proper parts for your application. The header number will be stamped on the engine flange. If you are unsure you have received the proper parts call before you start work.
PAGE 3
1. Place vehicle in a location where the floor is solid and flat, with adequate lighting. Do not attempt to work on a hot engine. Heat causes metal to expand and makes removal of fasteners difficult at best. Disconnect the negative battery cable from the battery. Raise the front of the vehicle to obtain adequate access to the bottom exhaust manifold flanges. Use large-base jack stands to support the vehicle. Do not rely on the jack! Block the tires to prevent the vehicle from rolling off the jack stands.
PAGE 4
Parts List: (1) Driver’s Side Header Assembly (1) Passenger’s Side Header Assembly (2) Header flange gaskets LIMITED ONE YEAR WARRANTY All JBA HEADERS and exhaust products are guaranteed, to the original purchaser, to be free of defects in materials and workmanship for one year. This warranty covers the replacement or repair of the product only and does not cover the cost of removal and installation, customer applied aftermarket coatings or any discoloration or corrosion of finished surfaces.
PAGE 5